The Robert Sorby Knife Sharpening Accessory Kit is a highly effective but simple to use system to create razor sharp edges on any style of knife blade from pocket and woodcarving knives to kitchen and hunting knives.

The fitting and setup of the Knife Sharpening system only takes a few minutes and the only piece of equipment required is a 13 mm wrench/spanner.

The kit contains the following:

• Raised Wear Plate / Back Plate
• Universal Arm
• Small Knife Holder with angle adjustment collar
• Large Knife Holder with angle adjustment collar
• Allen Key
• Wrench
• Aluminium Oxide Belt 60 grit (x1)
• Aluminium Oxide Belt 240 grit (x1)
• Trizact Belt 600 grit (x1)
• Trizact Belt 1200 grit (x1)
• Trizact Belt 3000 grit (x1)

We have selected these belts because they use an even cut rate and give a vastly prolonged belt life over standard abrasive belts. This produces knives and tools with consistent honed bevels and incredibly sharp cutting edges.

As with all abrasives, the belts should always be used in the order of grit from the coarsest to the finest. This is to maximise the efficiency of each belt and to achieve the best possible results.